Assess pipe diameter, blockage, length and water before specifying J-2050HS jetting/flushing.
Confirm the pipe route rather than pressure/flow alone
The J-2050HS is specified at 200 bar (20 MPa) and 50 L/min. Pressure disturbs pipe-wall deposits and flow carries out grit and wastewater. Check bore, pipe material, bends, access, deposits and the available water supply.
Establish the working reach for the actual line.
Long runs may require sectional work. Confirm nozzles, hose length and wastewater handling by project; ratings alone do not establish maximum pipe diameter or clearance distance.
Checks after reading
- Site area, routes and narrowest access
- Floor, dust, oil, debris or pipe-blockage type
- Daily frequency and continuous working time
- Power, water, wastewater, consumables and service conditions
Explore products and selection information
Site-based selection of20MPa /50L/min drain jetters: frequently asked questions
What does this article address?
Assess pipe diameter, blockage, length and water before specifying J-2050HS jetting/flushing.
What site information is needed before equipment selection?
Provide area, aisle width, floor/pipe conditions, contamination, frequency, power/water, city and budget range.
Should selection of a 200 bar (20 MPa), 50 L/min jetter include a site trial?
This article offers selection guidance. For complex sites, heavy contamination or continuous work, verify models and configurations through equipment information, video or a trial.