CN EN
Location:Home > Equipment selection > Selecting industrial vacuums for dust, metal chips, grit and fibres
Equipment selection

Selecting industrial vacuums for dust, metal chips, grit and fibres

Assess industrial vacuums by dust, metal chips, grit, fibres and wet-pickup requirements rather than power alone.

Selecting industrial vacuums for dust, metal chips, grit and fibres

Assess industrial vacuums by dust, metal chips, grit, fibres and wet-pickup requirements rather than power alone.

Select an industrial vacuum around the waste material. Offices and hotels prioritise noise and handling; hardware workshops need chip collection; textile workshops face fibrous dust and filter clogging; building-material and stone sites require attention to grit and container loading. Confirm hazardous-material restrictions separately.

For heavy dust loads and frequent use, compare filter area, collection capacity, filter-cleaning method and hose diameter rather than purchase price alone.

Checks after reading

  • Site area, routes and narrowest access
  • Floor, dust, oil, debris or pipe-blockage type
  • Daily frequency and continuous working time
  • Power, water, wastewater, consumables and service conditions
Related products

Explore products and selection information

FAQ

Selecting industrial vacuums for dust, metal chips, grit and fibres — questions

What does this article address?

Assess industrial vacuums by dust, metal chips, grit, fibres and wet-pickup requirements rather than power alone.

What site information is needed before equipment selection?

Provide area, aisle width, floor/pipe conditions, contamination, frequency, power/water, city and budget range.

After reading “Selecting industrial vacuums for dust, metal chips, grit and fibres”, is a site trial still needed?

This article offers selection guidance. For complex sites, heavy contamination or continuous work, verify models and configurations through equipment information, video or a trial.

Further reading

Related cleaning equipment information

Match the machine to the material and site

JGY-80P | Mobile vacuuming at separate workstations

For battery-powered mobile pickup, identify the material, obstacles, route and charging arrangements. Clear access before selecting the tool and collection route.

Assess this machine for your site →

JGY-2078SA | Workshop vacuuming by zone and filter care

A star filter and manual shaker work together. Check particle size, hazard and filter load. Verify media suitability and protection requirements separately from filter area.

Assess this machine for your site →

JGY-3070 | Routine wet and dry workshop cleaning

For routine wet/dry work and multiple stations, check particle type, temperature, daily quantity and mode changeover. Exclude hot chips, sparks and hazardous dust before selecting tools.

Assess this machine for your site →

JGY-3078P | Cold metal chips and workstation cleaning

Match collection and filtration to cold chips, dust properties and sharp edges. Exclude hot chips, sparks and hazardous dust from routine wet/dry pickup.

Assess this machine for your site →

JGY-3078BA | Matching the industrial vacuum variant to the task

Check the exact version, material and workplace. Identify the material and required protection before specifying equipment.

Assess this machine for your site →

JGY-3610P | Fibres, lint and lightweight debris

Check fibre length, tangling, volume and filter loading. Separately verify any certification required for combustible dust.

Assess this machine for your site →

JGY80-40 | Vacuuming at industrial power points

For a fixed industrial vacuum station, check the fan, filter, circuit, starting controls, operating duration and air-path load before installation.

Assess this machine for your site →

JGY100-75 | Large-bore material collection and separation

Match the turbine fan, airflow path, inlet size, container and separator to material density, particle size and hazards. Check limits for coarse or hazardous materials explicitly.

Assess this machine for your site →