CN EN

J-D9R · Selecting an 860mm ride-on scrubber

Distinguish cleaning width, machine dimensions and squeegee width before assessing a site.

Selecting an 860mm ride-on scrubber

Continuous main aisles

860mm twin-disc cleaning

Water servicing

140L solution / 150L recovery

Doors, lifts and transfers

160×90×132cm machine

Measure practical coverage on the main aisles

The twin discs give a nominal scrubbing width of 860 mm. Use a trial to judge overlap and actual coverage where aisles are partly occupied. Record areas around columns, rack ends and narrow bays separately. A smaller machine can cover those points if the route trial shows a clearance problem.

Include recovery and servicing in the trial

Pick a route with a straight run, a turn and typical soil. Note the finished floor, rear squeegee clearance during turns and travel time to the water point. Measure access with the complete machine and check lift load limits. Base the choice on the whole route.

View J-D9R specifications Discuss site suitability